When my wife sent me an inspiration photo for our new coffee table I knew I had just the right material for the job. I recently purchased a sheet of 3/4" walnut veneered plywood and didn't end up using it. However, I was unsure if it would be enough for this job. After designing it and laying it all out, I knew it could work. Using some techniques I've picked up over the years I was able to make a 46" round coffee table from a single sheet of plywood and it turned out even better than her or I could have ever expected. Plans: https://rogueengineer.com/diy-round-coffee-table-plans/ Kreg Jig 720 PRO: https://amzn.to/3Bga1j9 Learn more about Ryobi HP Tools: https://www.ryobitools.com/products/one-plus ------------------------------------------------- SUPPORT ROGUE ENGINEER Buy a shirt: http://bit.ly/rogueSHOP Shop on Amazon: http://bit.ly/rogueAMZN Shop at HomeDepot: http://bit.ly/rogueHD ------------------------------------------------- BE SOCIAL https://www.facebook.com/rogueengineer/ https://www.instagram.com/rogue_engineer/ https://www.pinterest.com/rogue_engineer/