In this video, we're going to build our own Bitcoin Full Node using a Raspberry Pi. By running your own node, you can skip using a third party, and directly make transactions on the Bitcoin network without any additional fees. You'll also be helping to keep the Bitcoin network decentralized. Visit my blog for the full written guide to building your own node - https://www.the-diy-life.com/build-run-your-own-bitcoin-node-on-a-raspberry-pi/ Get the 3D print and laser cutting files - https://www.etsy.com/listing/1019844618 What You Need To Build Your Bitcoin Node: Raspberry Pi 4B (8GB used) – https://amzn.to/3sh7zmY 32GB MicroSD Card (16GB Min) – https://amzn.to/3sbcEgR Low Profile Ice Tower (Black version used) - https://amzn.to/3th9r0x 1TB M.2 NVME SSD – https://amzn.to/3g91RBa External NVME Case (Not the one I used, but similar) - https://amzn.to/3e1rW2p 1TB External SSD (Alternative to above) – https://amzn.to/3a90Aq7 Raspberry Pi Power Supply – https://amzn.to/2QqbBfx Ethernet Cable - https://amzn.to/3uN4Gfl 4 x 3mm Yellow LEDs – https://amzn.to/3dhgKQ0 4 x 150ohm Resistors – https://amzn.to/32aBkLA M3 Screws & Nuts - https://amzn.to/2PRw6Cd Banggood Alternatives: 4 x 3mm Yellow LEDs - https://www.banggood.com/custlink/GvDYjFd2G5 4 x 150ohm Resistors - https://www.banggood.com/custlink/3vGdOFhqGi M3 Screws & Nuts - https://www.banggood.com/custlink/D3vylPE2mj 3D Printer Used – Creality Ender 3 V2 - https://amzn.to/3mM0qKA K40 Laser Cutter/Engraver Used - https://amzn.to/3jD8mKR The above parts are affiliate links. By purchasing products through the above links, you’ll be supporting this channel, with no additional cost to you. If you've got any ideas for Raspberry Pi, Arduino, or other Electronics projects or tutorials you'd like to see, let me know in the comments section.