Targeted Pemf /dilatational wave\ therapy through a FERRITE ROD with an EMF COIL wound around it, powered by a CLASS D audio amp... audio amp inputs from laptop sound card's(SAMPLE RATE=192kHZ) 2 PULSE GENERATORs and some timing software send the final dilatation wave treatment signal to the sound card's LINE OUTPUT... The FERRITE ROD/COIL is series tuned by a CAPACITOR to resonate at 75Khz. 75kHZ is used, as does FISHER-WALLACE, https://www.fisherwallace.com/pages/faq#how-it-works as a carrier wave to deliver the EMP pulses to the tissue of interest NOTE: This setup is using the FISHER-WALLACE carrier wave signal blocks(75Khz) method to deliver the magnetic treatment pulses(which allows a much smaller coil inductance value to decrease the weight of FERRITE TREATMENT WAND) The Pulse Width and Pulse Frequency are set by two pulse generators https://u.pcloud.link/publink/show?code=XZOfdy0Zxfw3pVL0n0VgxSKge7XB3kvuv0Hk The dilatational wave is the alternating output waveform of sparse waves and dense waves. https://www.ingentaconnect.com/content/cog/aetr/2021/00000046/00000004/art00012?crawler=true&mimetype=application/pdf TIMING SETUP: 1. gSTREAMER SETs UP a square wave at .1hz gst-launch-1.0 -v audiotestsrc wave=1 freq=.1 ! audioconvert ! jackaudiosink its output goes to a specialized C CODE script input written by chat GPT https://u.pcloud.link/publink/show?code=XZuy4y0Zv9cyCjvzL7y2n4UKY2D9n4zMHzs7 that divides the POS/NEG cycles of the input square wave from gstreamer with TWO mono phasic signal outputs... 2 channels... 1 channel goes to trigger the 1st pulse generator to pass its signal, the 2nd channel triggers the 2nd pulse generator to pass its signal to the CLASS D amp/input coil FERRITE treatement WAND(using 2 separate REAGATE sidechain gate plugins) FERRITE ROD is material 61, VERY HIGH RESISTANCE, will not conduct high voltage/current, into fingers holding the ROD or the TARGET TREATMENT TISSUE touching the end of the FERRITE ROD ************************************************************************** NOTE: DO NOT TRY THIS YOURSELF without your DOCTOR's advise and training, and a professional electronic technician looking over and checking the wiring and hardware ! The output from a setup like this can produce dangerous voltages & currents if you set its current/voltage too high on the circuit structure... *also*, FAIL-SAFE safety features must be included, to prevent accidental over current/voltage damage to the equipment or to you... DO NOT TRY THIS YOURSELF ! *************************************************************************** for more examples of building & using setups like this, see playlist:    • DiY build your own Microcurrent, pEMF...