Learn how to flush and fill the coolant in your car or truck. Keep your radiator, heater core, and engine clean. Flushing your coolant is good for the cooling system to prevent rust and to prevent your car from overheating. First you drain the old coolant from the radiator, then you fill it with distilled water and coolant flush chemical. Then you run the car. Then you drain the water from the radiator and fill it with 50/50 antifreeze. How to Superflush your Cooling System: https://www.youtube.com/watch?v=s--5ft5YiHg Here is How to Test your Cooling System: https://www.youtube.com/watch?v=mHTM3dvpD1M Here is how to Flush your Heater Core: https://www.youtube.com/watch?v=M9SIafVsqyc *If the video was helpful, remember to give it a "thumbs up" and consider subscribing. New videos every Thursday* -Website: https://www.ChrisFixed.com/ -Facebook: https://www.facebook.com/chrisfix8 -Twitter: https://twitter.com/ChrisFixed -Instagram: https://instagram.com/chrisfixit -Subscribe Here: null -YouTube Channel: null Disclaimer: Due to factors beyond the control of ChrisFix, I cannot guarantee against improper use or unauthorized modifications of this information. ChrisFix assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. Use this information at your own risk. ChrisFix recommends safe practices when working on vehicles and or with tools seen or implied in this video. Due to factors beyond the control of ChrisFix, no information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. Any injury, damage, or loss that may result from improper use of these tools, equipment, or from the information contained in this video is the sole responsibility of the user and not ChrisFix.