Today we will be working with the MPU-6050 IMU, and we will use it to build an electronic level with an Arduino. Article with libraries and code - https://dronebotworkshop.com/mpu-6050-level/ More articles and tutorials: https://dronebotworkshop.com/ Join the conversation on the forum: https://forum.dronebotworkshop.com/ Subscribe to the newsletter and stay in touch: https://dronebotworkshop.com/subscribe/ Today we will be working with the MPU-6050, a low-cost Inertial Measurement Unit, or IMU. This device has a lot of different applications in many fields including robotics, gaming, quadcopters, and IoT devices. The MPU-6050 has an internal gyroscope and accelerometer. It's an inexpensive device, available in several packages and modules. The module I am using is very common and has a built-0in voltage regulator so it can work with 5-volt logic. We will start by looking at the MPU-6050 internals, as well as at the pinout of the module I am using. Next, we will load a couple of libraries into our Arduino IDE and ruins some sample code to display Pitch, Yaw, and Roll. After that, we will build a small project, an electronic level. Our level will display on an LCD and will also use 5 LEDs to give a good visual indication of how level the surface is. Here are the contents for today's video: 00:00 - Introduction 02:53 - MPU-6050 Intro 11:20 - MPU-6050 Arduino Experiments 20:29 - Electronic Level You can get the sketch and the two libraries used in the experiments on the DroneBot Workshop website. Hope you enjoy the video!