In this episode of Cabin in the Woods, I continue the metal roof standing seam details by sharing how we install the valley pan at the peak where two valleys come together and a ridge cap will be terminating. This is one of the harder standing seam details in my opinion and I am sure there are many ways to do it. Please leave me a comment if you thought it was good, but more importantly, if you have another method or link to a video showing a different and better way. A lot have asked about the metal brake we have been using. It is the last piece in the puzzle of our snap table pro. It is a niche trailer filled with every tool you need to properly prep your standing seam panels. I will show it in its full glory soon. Snap Table Pro https://swensonshear.com/product/snaptable-pro-standing-seam-tool/ Midwest Snips Set - https://imp.i284638.net/m72PX Festool TID 18 - https://imp.i284638.net/y7g2b Stabila tech 700 - https://imp.i284638.net/RkDm7 Looking for good hearing protection on site or at home that also doubles as your radio, allows you to take phone calls, and has noise reduction? Check out ISOtunes! I've been wearing them for over a year and they've greatly helped reduce the ringing in my ears at night! http://bit.ly/2PoXSBw Use my Code to save!! RRB10 If you'd like to support RRBuildings, below are various ways to help! Shirts: https://rrbuildings.bigcartel.com/ Hats: https://www.beachandbarn.com/collections/kyle-stumpenhorst-rrbuildings Patreon: https://www.patreon.com/rrbuildings Instagram: https://www.instagram.com/rrbuildings