Learn how to get extreme steering angle for your drift car! Not only will you learn how to install an angle kit, but you will learn how to replace the entire front suspension including the lower control arm, wheel bearing, tie rods, coilovers, sway bar, steering knuckle, and brakes. Tools and Products Bump Steer Kit: http://amzn.to/2DvleBE Angle Kit: https://goo.gl/5ZiZQK Extendable Ratchet: http://amzn.to/2DzNH9x Wrench Set: http://amzn.to/2Dty2cA Torque Wrench (goes to 250ft-lbs):http://amzn.to/2DV6WrY Thread locker: http://amzn.to/2BfMCi2 Antiseize: http://amzn.to/2roe8Kz Electric Cutoff Wheel: http://amzn.to/2DlXvk8 Wheel Bearing: http://amzn.to/2DztiRM Stiffer Springs: http://amzn.to/2Dm936Q Thanks Chris Forsberg for footage of his car: null → Become a ChrisFix Subscriber: null → Instagram: https://www.instagram.com/chrisfixit → Facebook: https://www.facebook.com/chrisfix8 → Website: http://www.ChrisFixed.com/ → My Channel Home Page: null *If the video was helpful, remember to give it a "thumbs up" and consider subscribing. New videos every Week* Disclaimer: Due to factors beyond the control of ChrisFix, I cannot guarantee against improper use or unauthorized modifications of this information. ChrisFix assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. Use this information at your own risk. ChrisFix recommends safe practices when working on vehicles and or with tools seen or implied in this video. Due to factors beyond the control of ChrisFix, no information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. Any injury, damage, or loss that may result from improper use of these tools, equipment, or from the information contained in this video is the sole responsibility of the user and not ChrisFix.