Face ID Not Working 'Move iPhone a Little Lower/Higher' is usually caused by damage to the dot projector and the problem is confirmed to be almost unrepairable. However, there is finally a solution to fix the problem. Check out our iPhone XS MAX Face ID repair video today and learn the latest dot projector repair technique! Products recommended in this video: JC Pro1000s Pcie Nand Read & Write Programmer: https://bit.ly/2SbSCTH Face ID Dot Matrix Detection Module: https://bit.ly/3ifHBeN Dot Projector Flex Cable (For iPhone X): https://bit.ly/2GrjrAz Intelligent Preheating Platform (Designed for Face ID) : https://bit.ly/3494AD3 Face ID Lattice Repair Hold Fixture: https://bit.ly/2ScRoaU The Sandalwood Knife Kits: https://bit.ly/3jfJR6R iPhone Logic Board Repair Cases Course: https://bit.ly/3ienYUq 00:00 Intro 00:14 iPhone XS Max Face ID Not Working Fixed - Dot Projector Repair 03:23 Separate The Crystal From The Cable 04:31 Burn Data 05:36 Jump-wiring The MOSFET 06:51 Solder The Dot Projector Module 10:44 Glue A Known-good Crystal 11:19 Test Any questions and demands please feel free to contact us at: sales@rewatechnology.com Subscribe us for more latest information. ----------------------------------------------------------------------------------------- Official Website: https://rewa.tech/ Blog: https://blog.rewatechnology.com/ Facebook: https://www.facebook.com/rewatechnology/ Instagram: https://www.instagram.com/rewatechnology/ -----------------------------------------------------------------------------------------